Headlight Size

Subaru BRZ Headlight Assembly Replacement Guide


Subaru is a Japanese car-making giant known as Fuji Heavy Industries. It is now considered to be one of the largest automobile manufacturers all over the world. Their Subaru BRZ is a popular vehicle produced in collaboration with Toyota. It comes with a boxer engine and a rear-wheel-drive system.

When you plan for a Subaru BRZ headlight assembly upgrade, finding out the correct replacement size can be a time-consuming task. Whether it is the headlight assembly or even the headlight bulbs, looking for the right size is essential as it can be convenient for you when driving at night. Before you rely on any other information, it is also necessary to check the bulb’s voltage, wattage, and size.

When to change the headlight bulbs of Subaru BRZ?

When you notice a few signs in the headlight assembly of your Subaru BRZ, then you need to replace it with a new one.

  • Headlight not functioning

If one of the headlights of your Subaru BRZ burns out, then you can face difficulties, especially when going through the dark roads at night time. In addition to that, it is also an indication for you that you need to replace the headlight.

  • Blinking headlights

Some low-quality front lights start blinking over time. The filament getting damaged is the main reason for this blinking, and it also causes the flickering of light. Therefore, when having a headlight kit replacement, you need to address this problem and handle it promptly.

  • Headlights have low-intensity

There are times when scratches occur on the outer plastic cover of the headlight. Besides this, you may also see dirt layers across the body that make the light dim. It is essential to properly clean the outer surface and check the brightness of the light. The intensity of the light gets affected over time.

A guide on replacing the headlight assembly of 2013 Subaru BRZ

The primary step for you is to open the hood of your 2013 Subaru BRZ and reach the headlight assembly to access the plastic base. You can now push in the release tab of the electrical connector and take out the headlight assembly. It is better not to touch the glass part of the bulb with the fingers.

Now you can insert the new headlight assembly into the housing and reach the engine for accessing the rear of the housing. To test the new headlight assembly, you need to turn on the headlights and flash the high beams. Make sure that you have the service records of the headlight assembly replacement.

How to aim and align the headlight assembly of the 2013 Subaru BRZ?

  • Start by parking the 2013 Subaru BRZ on a flat surface with the headlights turned on pointed towards a small wall.
  • Now lift the hood and open it with the help of a prop arm.
  • Measure the ground’s height to the middle of the headlight assembly with the help of a measuring tape.
  • Now attach a painter’s tape on the wall where the headlights are aimed.
  • With the help of the adjustment bolts, you can locate the back of the headlight assembly. Adjust the headlights so that the center remains around two inches below the tape.

Conclusion

When you look for the best headlight assembly for your Subaru BRZ, it is better not to set for anything below the premium quality. When you have a Subaru BRZ headlight assembly upgrade, many top manufacturers make sure that you get guaranteed functionality and durability. In addition to that, the headlight assembly should also fit the original OEM and should be approved.


Leave a Reply

Your email address will not be published.